CUSTOMIZE PARAMETERS CUSTOMIZE BLIND SPOT MONITOR SYSTEM (a) Customizing with the Techstream NOTICE:
(1) Connect the Techstream to the DLC3. (2) Turn the ignition switch to ON. (3) Turn the blind spot monitor system on. (4) Turn the Techstream on. (5) Enter the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Utility / Customize / Warning. (6) Select the setting by referring to the table below. Warning
(b) Customizing with multi information display NOTICE:
(1) Turn the ignition switch to ON. (2) Turn the blind spot monitor system on. (3) Enter the following menus: Settings / Vehicle Settings (4) Select the setting by referring to the table below. Blind Spot Monitor Setting
|
Toyota Tundra Service Manual > Combination Meter: Removal
REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. Click here 2. D ...