DTC CHECK / CLEAR 1. CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the blind spot monitor system on. (d) Turn the Techstream on. (e) Enter the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Trouble Codes. HINT: The blind spot monitor sensor RH and the blind spot monitor sensor LH both output DTCs. Therefore, check both blind spot monitor sensors for DTCs. (f) Check for DTCs (See page
2. CLEAR DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the blind spot monitor system on. (d) Turn the Techstream on. (e) Enter the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Trouble Codes. (f) Clear the DTCs. |
Toyota Tundra Service Manual > Rear View Monitor System(for Radio And Display Type): Reverse Signal Circuit
DESCRIPTION The radio and display receiver assembly receives a reverse signal from the park/neutral position switch assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this system before performing the following procedure. PROCEDURE 1. CHECK VEHICLE SIG ...
).
