REMOVAL PROCEDURE 1. REMOVE INSTRUMENT SIDE PANEL LH 2. REMOVE FRONT DOOR SCUFF PLATE LH 3. REMOVE COWL SIDE TRIM BOARD LH 4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH 5. REMOVE NO. 2 SWITCH HOLE BASE 6. REMOVE BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY
|
Toyota Tundra Service Manual > Rear Axle Shaft: Inspection
INSPECTION PROCEDURE 1. INSPECT REAR AXLE SHAFT (a) Using a dial indicator, measure the rear axle shaft runout and flange runout. Maximum runout: Shaft runout 1.50 mm (0.0591 in.) Flange runout 0.05 mm (0.00197 in.) If the rear axle shaft or flange is damaged or worn, or if the runout is greater tha ...
