DTC CHECK / CLEAR 1. DTC CHECK/CLEAR (a) Check for DTCs. (1) Connect the Techstream to the DLC3. (2) Turn the ignition switch to ON. (3) Turn the Techstream on. (4) Read the DTCs following the prompts on the Techstream. Enter the following menus: Chassis / Trailer Brake Controller / Trouble Codes. (b) Clear the DTCs. (1) Connect the Techstream to the DLC3. (2) Turn the ignition switch to ON. (3) Turn the Techstream on. (4) Operate the Techstream to clear the codes. Enter the following menus: Chassis / Trailer Brake Controller / Trouble Codes. (5) According to the display on the Techstream, select the trouble code data display with the clear button. |
Toyota Tundra Service Manual > Differential Carrier Oil Seal(for 1ur-fe): Replacement
REPLACEMENT PROCEDURE 1. DRAIN DIFFERENTIAL OIL 2. REMOVE PROPELLER SHAFT ASSEMBLY (a) Remove the propeller shaft for 2WD (See page ). (b) Remove the propeller shaft for 4WD (See page ). 3. REMOVE REAR DRIVE PINION NUT (a) Using SST and a hammer, loosen the staked part of the nut. SST: 09930-00010 ( ...
