Toyota Tundra Service Manual: Inspection

Toyota Tundra Service Manual / Brake / Brake Control / Dynamic Control Systems / Vsc Off Switch / Inspection

INSPECTION

PROCEDURE

1. INSPECT VSC OFF SWITCH

(a) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Switch Condition

Specified Condition

6 - 9

Pressed

Below 1 Ω

Not pressed

10 kΩ or higher

If the result is not as specified, replace the VSC OFF switch.
    Components

    Installation

    See More:

    Toyota Tundra Service Manual > Front Axle Hub: On-vehicle Inspection
    ON-VEHICLE INSPECTION PROCEDURE 1. REMOVE FRONT WHEEL 2. DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH 3. REMOVE FRONT DISC 4. REMOVE FRONT AXLE HUB GREASE CAP LH (for 4WD) 5. INSPECT FRONT AXLE HUB BEARING LOOSENESS (a) Using a dial indicator, measure the looseness near the center of the axle hub ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.01