Toyota Tundra Service Manual: Installation

INSTALLATION

PROCEDURE

1. INSTALL RADIATOR ASSEMBLY

(a) Install a new O-ring to the radiator drain cock plug.

(b) Install the radiator drain cock plug to the radiator assembly.

(c) Install the outlet radiator hose to the radiator assembly, and slide the clamp to secure the hose.

HINT:

Install the hose so that the direction of the hose clamp is as indicated in the illustration.

(d) Set the radiator bracket hooks to the radiator support holes.

(e) Install the radiator assembly with the 4 bolts.

Torque:

18 N·m {184 kgf·cm, 13 ft·lbf}

2. CONNECT RADIATOR SIDE DEFLECTOR LH

(a) Install the 3 clips to connect the radiator side deflector LH.

3. CONNECT RADIATOR SIDE DEFLECTOR RH

(a) Install the 3 clips to connect the radiator side deflector RH.

4. CONNECT OUTLET RADIATOR HOSE

5. INSTALL FAN SHROUD

(See page )

6. INSTALL RADIATOR GRILLE SUB-ASSEMBLY

(See page )

    Components

    On-vehicle Inspection

    See More:

    Toyota Tundra Service Manual > Sfi System: Secondary Air Injection System Switching Valve Stuck Open Bank1 (P2440-P2443)
    DESCRIPTION Refer to DTC P0412 (See page ). DTC No. DTC Detection Condition Trouble Area P2440 Cumulative pressure pulsation is 60 kPa (450 mmHg) or more for 2 seconds (1 trip detection logic). Air switching valve (ASV) assembly Open or short in ASV circuit Secondary air injection system piping Pres ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2021 Copyright www.ttundra.com
    0.0146