REMOVAL PROCEDURE 1. REMOVE FAN SHROUD (See page 2. REMOVE WATER INLET SUB-ASSEMBLY WITH THERMOSTAT (See page 3. REMOVE NO. 1 WATER BY-PASS HOSE
4. DISCONNECT NO. 8 WATER BY-PASS HOSE
5. DISCONNECT NO. 5 WATER BY-PASS HOSE
6. REMOVE WATER INLET HOUSING
(b) Remove the gasket from the water pump assembly. 7. REMOVE WATER PUMP PULLEY
(b) Remove the 4 bolts and water pump pulley. 8. REMOVE WATER PUMP ASSEMBLY
|
Toyota Tundra Service Manual > Cylinder Block: Replacement
REPLACEMENT PROCEDURE 1. REPLACE STRAIGHT PIN NOTICE: It is not necessary to remove the straight pin unless it is being replaced. (a) Remove the straight pins. (b) Using a plastic-faced hammer, tap in new straight pins to the cylinder block. Standard Straight Pin: Item Height Width Protrusion Pin A ...
)
