Toyota Tundra Service Manual: Inspection

Toyota Tundra Service Manual / Engine, Hybrid System / 1ur-fe Engine Control / Camshaft Oil Control Valve / Inspection

INSPECTION

PROCEDURE

1. INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 - 2

20°C (68°F)

6.9 to 7.9 Ω

If the result is not as specified, replace the camshaft timing oil control valve assembly.

(b) Connect the battery's positive (+) lead to terminal 1 and the negative (-) lead to terminal 2, and check the movement of the valve.

OK:

Condition

Specified Condition

Battery positive (+) voltage is applied

Valve moves in left arrow direction shown in the illustration

Battery positive (+) voltage is cut off

Valve moves in right arrow direction shown in the illustration

If the result is not as specified, replace the camshaft timing oil control valve assembly. If the valve cannot return properly because of foreign matter, a small pressure leak in the advanced direction may occur and a DTC may be output.
    Components

    Installation

    See More:

    Toyota Tundra Service Manual > Front Seat Inner Belt Assembly(for Center Seat): Removal
    REMOVAL PROCEDURE 1. REMOVE FRONT SEAT ASSEMBLY LH (a) for Power Seat: Remove the front seat (see page ). (b) for Manual Seat: Remove the front seat (see page ). 2. REMOVE FRONT SEAT ASSEMBLY RH (a) for Power Seat: Remove the front seat (see page ). (b) for Manual Seat: Remove the front seat (see pa ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.039