On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT MAIN BODY ECU (ACC RELAY)  (a) Measure the resistance of the ACC relay circuit. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the main body ECU. |
Toyota Tundra Service Manual > Blind Spot Monitor System: Lost Communication with Blind Spot Monitor Slave Module (U0232)
DESCRIPTION This DTC is stored when the blind spot monitor sensor RH judges that there is a communication problem with the blind spot monitor sensor LH. DTC No. DTC Detection Condition Trouble Area U0232 The blind spot monitor sensor (master) cannot receive signals from the blind spot monitor sensor ...
