Toyota Tundra Service Manual: Removal

Toyota Tundra Service Manual / Engine, Hybrid System / A760e Automatic Transmission / Transaxle / Park / Neutral Position Switch / Removal

REMOVAL

PROCEDURE

1. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Remove the nut and disconnect the cable.

2. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY

(a) Disconnect the switch connector.

(b) Remove the nut, spring washer and transmission control shaft lever RH.

(c) Using a screwdriver, bend the tabs of the lock washer.

(d) Remove the lock nut and lock washer.

(e) Remove the bolt and switch.

HINT:

Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch as the detent spring may become detached from the manual valve lever shaft.
    On-vehicle Inspection

    Shift Lever Assembly(for Column Shift Type)

    See More:

    Toyota Tundra Service Manual > Rear Bumper (for Steel Type Bumper): Disassembly
    DISASSEMBLY PROCEDURE 1. REMOVE REAR BUMPER PLATE LH (a) Detach the 3 claws and clip and remove the rear bumper plate LH. 2. REMOVE REAR BUMPER PLATE RH HINT: Use the same procedure described for the LH side. 3. REMOVE REAR BUMPER PAD SUB-ASSEMBLY LH (a) Remove the 3 clips. (b) Detach the 12 claws a ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0347