Toyota Tundra Service Manual: Removal

Toyota Tundra Service Manual / Engine, Hybrid System / A760e Automatic Transmission / Transaxle / Shift Lever Assembly(for Column Shift Type) / Removal

REMOVAL

PROCEDURE

1. REMOVE TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY

(See page )

2. REMOVE COLUMN SHIFT ASSEMBLY

(a) Move the shift lever to N.

(b) Disconnect the column shift transmission control cable end from the column shift.

(c) Disconnect the connector and detach the harness clamp.

(d) Using a T30 "TORX" wrench, remove the 3 bolts and column shift.

    Reassembly

    Shift Lever Assembly(for Floor Shift Type)

    See More:

    Toyota Tundra Service Manual > Front Propeller Shaft Assembly: Disassembly
    DISASSEMBLY PROCEDURE 1. REMOVE FRONT PROPELLER SHAFT JOINT SPIDER BEARING SNAP RING (a) Place matchmarks on the flange yoke. Text in Illustration *a Matchmark (b) Using a brass bar and hammer, slightly tap in the spider bearing outer races. (c) Using needle-nose pliers, remove the 4 snap rings from ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0143