Toyota Tundra Service Manual: Inspection

Toyota Tundra Service Manual / Engine, Hybrid System / A760e Automatic Transmission / Transaxle / Shift Lever Assembly(for Floor Shift Type) / Inspection

INSPECTION

PROCEDURE

1. INSPECT TRANSMISSION CONTROL SWITCH

(a) Disconnect the transmission control switch connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

3 (IG) - 7 (S)

Shift lever position S, "+" or "-"

Below 1 Ω

2 (SFTU) - 5 (E)

Shift lever position continuously shifted to "+" (Up-shift)

1 (SFTD) - 5 (E)

Shift lever position continuously shifted to "-" (Down-shift)

3 (IG) - 7 (S)

Shift lever position not in S

10 kΩ or higher

2 (SFTU) - 5 (E)

Shift lever position S

1 (SFTD) - 5 (E)
Text in Illustration

*a

Component without harness connected

(Transmission Control Switch)

If the result is not as specified, replace the transmission floor shift assembly.
    Disassembly

    Installation

    See More:

    Toyota Tundra Service Manual > Differential Carrier Assembly(for 1ur-fe): Removal
    REMOVAL PROCEDURE 1. REMOVE REAR WHEEL 2. REMOVE PROPELLER SHAFT ASSEMBLY (a) Remove the propeller shaft for 2WD (See page ). (b) Remove the propeller shaft for 4WD (See page ). 3. DRAIN DIFFERENTIAL OIL 4. REMOVE REAR AXLE SHAFT LH (a) Remove the rear axle shaft LH (See page ). 5. REMOVE REAR AXLE ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0101