Toyota Tundra Service Manual: Removal

Toyota Tundra Service Manual / Engine, Hybrid System / A760e Automatic Transmission / Transaxle / Shift Lever Assembly(for Floor Shift Type) / Removal

REMOVAL

PROCEDURE

1. REMOVE CONSOLE BOX ASSEMBLY

(See page )

2. REMOVE NO. 1 CONSOLE BOX DUCT (w/ Rear Air Duct)

(a) Remove the 2 clips and No. 1 console box duct.

3. REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY

(a) Move the shift lever to N.

(b) Disconnect the transmission control cable end from the shift lever assembly.

(c) Remove the clip and disconnect the transmission control cable assembly from the shift lever retainer.

(d) Disconnect the clamp and 2 connectors from the shift lever assembly.

(e) Remove the 4 bolts and shift lever assembly.

    Reassembly

    Shift Lock System

    See More:

    Toyota Tundra Service Manual > Starter(for 2.0 Kw Type): Reassembly
    REASSEMBLY PROCEDURE 1. INSTALL STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY (a) Apply high-temperature grease to the areas of the starter pinion drive lever indicated in the illustration. (b) Install the starter pinion drive lever and rubber seal to the starter center bearing clutch. (c) Install the ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2025 Copyright www.ttundra.com
    0.0112