Toyota Tundra Service Manual: Installation

INSTALLATION

PROCEDURE

1. INSTALL TRANSMISSION VALVE BODY ASSEMBLY

(a) Install the spring and check ball body.

(b) Align the hole of the manual valve with the pin of the lever and connect the pin to the manual valve.

Torque:

11 N·m {112 kgf·cm, 8 ft·lbf}

HINT:

Each bolt length is indicated below.

36 mm (1.42 in.) for bolt A

25 mm (0.984 in.) for bolt B

45 mm (1.77 in.) for bolt C

50 mm (1.97 in.) for bolt D

(d) Install the detent spring and detent spring cover with the bolt.

Torque:

10 N·m {102 kgf·cm, 7 ft·lbf}

2. CONNECT TRANSMISSION WIRE

3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY

4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

5. ADD AUTOMATIC TRANSMISSION FLUID

(a) Add automatic transmission fluid (See page ).

Toyota Tundra Service Manual > Multiplex Tilt And Telescopic Ecu(for Power Tilt And Power Telescopic Steering Column): Installation
INSTALLATION PROCEDURE 1. INSTALL MULTIPLEX TILT AND TELESCOPIC ECU (a) Attach the claw to install the multiplex tilt and telescopic ECU. (b) Connect the ECU connector. 2. INSTALL NO. 3 AIR DUCT SUB-ASSEMBLY Click here 3. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY Click here 4. INSTALL LOW ...

Toyota Tundra Owners Manual