REMOVAL PROCEDURE 1. REMOVE NO. 1 ENGINE UNDER COVER 2. REMOVE DIFFERENTIAL VACUUM ACTUATOR ASSEMBLY  (a) Disconnect the differential actuator hose. (b) Disconnect the differential actuator connector. (c) Remove the 4 bolts and differential vacuum actuator assembly. |
Toyota Tundra Service Manual > Headlight Assembly(for Led Headlight): Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. A bolt without a torque specification is shown in the standard bolt chart (See page ). PROCEDURE 1. INSTALL HEADLIGHT ASSEMBLY LH (a) Connect each connector and a ...
