Toyota Tundra Service Manual: Installation

INSTALLATION

PROCEDURE

1. INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY

(a) Clean the contact surfaces of the rear differential carrier and rear axle housing.

(b) Install a new gasket and the differential carrier with the 10 washers and 10 nuts.

Torque:

72 N·m {734 kgf·cm, 53 ft·lbf}

NOTICE:

Be careful not to damage the contact surfaces of the differential carrier and rear axle housing.

2. INSTALL REAR AXLE SHAFT LH

(a) Install the rear axle shaft LH (See page ).

3. INSTALL REAR AXLE SHAFT RH

HINT:

Use the same procedure described for the LH side.

4. INSTALL PROPELLER SHAFT ASSEMBLY

(a) Install the propeller shaft for 2WD (See page ).

(b) Install the propeller shaft for 4WD (See page ).

5. ADD DIFFERENTIAL OIL

6. INSTALL REAR WHEEL

(a) Install the rear wheels.

Torque:

for aluminum wheel :

131 N·m {1336 kgf·cm, 97 ft·lbf}

for steel wheel :

209 N·m {2131 kgf·cm, 154 ft·lbf}