Toyota Tundra Service Manual: Reassembly

REASSEMBLY

PROCEDURE

1. INSTALL FRONT UPPER BALL JOINT DUST COVER LH

(a) Pack the upper arm ball joint with MP grease.

Grease capacity:

5.0 to 7.0 g (0.176 to 0.247 oz.)

(b) Using a snap ring expander, install the dust cover set ring.

2. INSTALL FRONT SUSPENSION UPPER ARM BUSH

(a) Using SST and a press, press in a new bush.

SST: 09710-26011

09710-05061

    Installation

    Removal

    See More:

    Toyota Tundra Service Manual > Front Drive Shaft Assembly(for 4wd): Disassembly
    DISASSEMBLY PROCEDURE 1. REMOVE INBOARD JOINT BOOT CLAMP (a) Using a side cutter, cut the 2 inboard joint boot clamps and remove them. 2. DISCONNECT INBOARD JOINT BOOT (a) Disconnect the inboard joint boot from the inboard joint shaft. 3. REMOVE INBOARD JOINT SHAFT (a) Place matchmarks on the inboar ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2025 Copyright www.ttundra.com
    0.0343