Toyota Tundra Service Manual: Cannot Switch to Automatic ID Registration Mode

Toyota Tundra Service Manual / Engine, Hybrid System / Tire And Wheel / Tire Pressure Warning System / Cannot Switch to Automatic ID Registration Mode

DESCRIPTION

When the tire pressure warning reset switch is turned on and off 3 times within 3 seconds (pressed → released → pressed → released → pressed → released), the tire pressure warning ECU and receiver switches to ID registration mode according to the automatic ID registration function.

When the system enters ID registration mode, the tire pressure warning light blinks 3 times as an answer back function.

The main body ECU (multiplex network body ECU) receives signals from the combination meter assembly via the CAN communication line.

WIRING DIAGRAM

Click here

PROCEDURE

1.	CHECK TEST MODE (TIRE PRESSURE WARNING RESET SWITCH CHECK [DTC C2198/98])

(a) Perform the test mode inspection and check for the tire pressure warning reset switch check item (DTC C2198/98).

Click here

GO TO DTC C2198/98

Initialization Switch (for Test Mode DTC) (C2198/98)

Data List / Active Test

See More:

Toyota Tundra Owners Manual > Adjusting the seats: Rear seats
Raising the bottom cushion 1. Use the seat belt hangers to prevent the belts from being tangled. 2. Pull and release the lever to unlock while raising the bottom cushion until it locks. When returning the bottom cushion to its original position, pull and release the lever, then carefully lower the b ...