ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT COOLER CONDENSER ASSEMBLY (a) If the fins of the cooler condenser are dirty, clean them with water. Dry the fins with compressed air. NOTICE: Do not damage the fins of the condenser. (b) If a fin of the cooler condenser is bent, straighten it using a screwdriver or pliers. 2. CHECK CONDENSER FOR LEAKAGE OF REFRIGERANT (a) Using a halogen leak detector, check the pipe joints for gas leakage. (b) If gas leakage is detected in a joint, check the torque of the joint. |
Toyota Tundra Service Manual > Rear View Monitor System(for Navigation Receiver Type): Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART HINT: If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below. Rear View Monitor System DTC Code Detection Item See page C1622 Open or Short Circuit in Back Camera Signal ...
