Toyota Tundra Service Manual: Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
A bolt without a torque specification is shown in the standard bolt chart (See page ).

PROCEDURE

1. INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH

2. INSTALL FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

3. INSTALL FRONT DOOR LOCK ASSEMBLY LH

4. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH

5. INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH

6. INSTALL FRONT DOOR SERVICE HOLE COVER LH

7. INSTALL FRONT NO. 1 DOOR TRIM BRACKET

8. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

9. INSTALL FRONT DOOR ARMREST COVER LH

10. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

11. INSTALL FRONT UPPER ARMREST BASE PANEL LH

12. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Toyota Tundra Service Manual > Tire Pressure Warning System: Cannot Switch to Automatic ID Registration Mode
DESCRIPTION When the tire pressure warning reset switch is turned on and off 3 times within 3 seconds (pressed → released → pressed → released → pressed → released), the tire pressure warning ECU and receiver switches to ID registration mode according to the automatic ID registration funct ...

Toyota Tundra Owners Manual