Toyota Tundra Service Manual: On-vehicle Inspection

Toyota Tundra Service Manual / Vehicle Interior / Engine Hood / Door / Hood / On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT HOOD SUB-ASSEMBLY

(a) Check that the clearance measurements of areas A to D are within the standard range.

Standard Clearance:

Area

Specified Condition

A

3.7 to 6.7 mm (0.146 to 0.264 in.)

B

-1.5 to 1.5 mm (-0.0591 to 0.0591 in.)

C

(Reference)

25.25 to 28.25 mm (0.995 to 1.113 in.)

D

(Reference)

5.6 to 8.6 mm (0.220 to 0.339 in.)
    Disassembly

    Reassembly

    See More:

    Toyota Tundra Service Manual > Vehicle Stability Control System: Problem Symptoms Table
    PROBLEM SYMPTOMS TABLE If there are no DTCs output and the problem still occurs, check the suspected areas for each problem symptom in the order given in the following table and proceed to the relevant troubleshooting page. NOTICE: When replacing the skid control ECU (brake actuator assembly), senso ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0168