FREEZE FRAME DATA 1. CHECK FREEZE FRAME DATA (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Navigation System / Trouble Codes. (e) Select a PTC to display its Freeze Frame Data. 2. LIST OF FREEZE FRAME DATA (a) Refer to "Data List / Active Test" (See page
|
Toyota Tundra Service Manual > Brake Control / Dynamic Control Systems: Stop Light Control Relay
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. CHECK STOP LIGHT CONTROL RELAY (a) Remove the stop light control relays (BRK NO. 1) from the engine room relay block. (b) Measure the resistance according to the value(s) in the table below. Standard resistance: for BRK NO. 1 Tester Connection ...
).
