DISASSEMBLY PROCEDURE 1. REMOVE BOX BOTTOM MAT
2. REMOVE NO. 1 SPEAKER HOLE COVER
3. REMOVE FRONT NO. 4 SPEAKER ASSEMBLY
4. REMOVE NO. 1 INSTRUMENT PANEL PIN
5. REMOVE DEFROSTER NOZZLE ASSEMBLY
6. REMOVE NO. 2 HEATER TO REGISTER DUCT
7. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT
8. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT
9. REMOVE INSTRUMENT CLUSTER FINISH PANEL REINFORCEMENT
10. REMOVE NAVIGATION ANTENNA ASSEMBLY (w/ Navigation System)
11. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY
|
Toyota Tundra Service Manual > Tail Gate: Installation
INSTALLATION PROCEDURE 1. INSTALL TAIL GATE MALE HINGE SUB-ASSEMBLY LH (a) Using a T40 "TORX" wrench, install the tail gate lock male hinge sub-assembly with the 2 screws. Torque: 29 N·m {296 kgf·cm, 21 ft·lbf} 2. INSTALL TAIL GATE MALE HINGE SUB-ASSEMBLY RH (a) Using a T40 "TORX&q ...
