Toyota Tundra Service Manual: Front Door Courtesy Switch

Components

COMPONENTS

ILLUSTRATION

*A	for Double Cab	-	-
*1	FRONT DOOR COURTESY SWITCH	-	-

ILLUSTRATION

*A	for CrewMax	-	-
*1	FRONT DOOR COURTESY SWITCH	-	-

Inspection

INSPECTION

PROCEDURE

1. INSPECT FRONT DOOR COURTESY SWITCH

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Switch Condition	Specified Condition
1 - Switch body	Pushed	10 kΩ or higher
1 - Switch body	Not pushed	Below 1 Ω

If the result is not as specified, replace the front door courtesy switch.

Text in Illustration

Component without harness connected

(Front Door Courtesy Switch)

Pushed

Not pushed

Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart (See page ).

PROCEDURE

1. INSTALL FRONT DOOR COURTESY SWITCH

(a) Connect the connector.

(b) Using a T30 "TORX" socket wrench, install the front door courtesy switch with the screw.

Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

PROCEDURE

1. REMOVE FRONT DOOR COURTESY SWITCH

(a) Using a T30 "TORX" socket wrench, remove the screw.

(b) Disconnect the connector and remove the front door courtesy switch.

Toyota Tundra Service Manual > Automatic Transmission System: Pressure Control Solenoid "A" Electrical (Shift Solenoid Valve SL1) (P0748)
DESCRIPTION Shifting from 1st to 6th is performed in combination with the ON and OFF operation of the shift solenoid valves SL1, SL2, S1, S2, S3, S4 and SR, which are controlled by the ECM. If an open or short circuit occurs in the shift solenoid valves, the ECM controls the remaining normal shift s ...

Toyota Tundra Owners Manual