Toyota Tundra Service Manual: Disassembly

DISASSEMBLY

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH and LH sides.
  • The procedure listed below is for the LH side.

PROCEDURE

1. REMOVE REAR TURN SIGNAL LIGHT BULB

(a) Turn the rear turn signal light bulb socket with the rear turn signal light bulb in the direction indicated by the arrow to remove them as a unit.

(b) Remove the rear turn signal light bulb from the rear turn signal light bulb socket.

2. REMOVE BACK UP LIGHT BULB

(a) Turn the back up light bulb socket with the back up light bulb in the direction indicated by the arrow to remove them as a unit.

(b) Remove the back up light bulb from the back up light bulb socket.

3. REMOVE TAIL AND STOP LIGHT BULB

(a) Turn the tail and stop light bulb socket with the tail and stop light bulb in the direction indicated by the arrow to remove them as a unit.

(b) Remove the tail and stop light bulb from the tail and stop light bulb socket.

    Components

    Installation

    See More:

    Toyota Tundra Service Manual > Sfi System: Secondary Air Injection System Driver (P1613,P1614)
    DESCRIPTION Refer to DTC P0412 (See page ). DTC No. DTC Detection Condition Trouble Area P1613 P1614 Either of following conditions (1) or (2) met: (1) All of following conditions met (1 trip detection logic): Either air pump or air switching valve not operating Diagnostic signal from Air Injection ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2024 Copyright www.ttundra.com
    0.0114