Toyota Tundra Service Manual: No Sound can be Heard from Speakers

CAUTION / NOTICE / HINT

HINT:

When the "iPhone" is connected to the USB port of the No. 1 stereo jack adapter, Entune audio may not be output. Before performing troubleshooting, disconnect the "iPhone" connected to the USB port of the No. 1 stereo jack adapter, change the audio output source of the "iPhone" or turn the ignition switch off and then ON again.

PROCEDURE

1.

CHECK AUDIO SETTINGS

(a) In sound output setting mode, set volume, fader and balance to the initial values and check that the sound is normal.

OK:

Audio system returns to normal.

HINT:

Sound quality adjustment measures vary according to the type of amplifier.

OK

END

NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

    Navigation Voice Circuit

    Noise Occurs or Sound Skips when Portable Player Plays

    See More:

    Toyota Tundra Service Manual > Pre-collision System: Diagnostic Trouble Code Chart
    DIAGNOSTIC TROUBLE CODE CHART Pre-collision System DTC No. Detection Item Link C1A02 Vehicle Information Not Obtained C1A10 Front Radar Sensor C1A11 Front Radar Sensor Incorrect Axial Gap C1A14 Front Radar Sensor Beam Axis Not Adjusted C1A46 Yaw Rate Sensor C1A47 Steering Angle Sensor C1A4A Skid Con ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0389