DESCRIPTION This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor LH. HINT: This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that beam axis inspection is performed. Completing the beam axis inspection after replacing a blind spot monitor sensor prevents this DTC from being output.
PROCEDURE
(a) Change the blind spot monitor sensor LH to Test Mode using the Techstream. HINT: Refer to Blind Spot Monitor Beam Axis Inspection (See page
|
Toyota Tundra Service Manual > Automatic Transmission System: Gear 6 Incorrect Ratio (P0729)
DESCRIPTION The ECM uses signals from the output speed sensor SP2 and input speed sensor NT to detect the actual gear position (1st, 2nd, 3rd, 4th, 5th or 6th gear). Then the ECM compares the actual gear with the shift schedule in the ECM memory to detect mechanical problems of the shift solenoid va ...
