INSTALLATION PROCEDURE 1. INSTALL BLIND SPOT MONITOR BUZZER (a) Attach the clamp to install the blind spot monitor buzzer. (b) Connect the connector. 2. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH
3. INSTALL LOWER QUARTER PANEL ASSEMBLY LH 4. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH 5. INSTALL REAR DOOR SCUFF PLATE LH 6. INSTALL REAR SEAT ASSEMBLY
7. INSTALL SEAT FLOOR BOX
8. INSTALL LUGGAGE COMPARTMENT SIDE COVER SUB-ASSEMBLY RH 9. INSTALL LUGGAGE COMPARTMENT SIDE COVER SUB-ASSEMBLY LH |
Toyota Tundra Service Manual > 1ur-fe Starting: Starter Relay
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. REMOVE STARTER RELAY (ST) (a) Remove the engine room relay box cover. (b) Remove the starter relay from the engine room relay block. 2. INSPECT STARTER RELAY (a) Measure the resistance according to the value(s) in the table below. Standard Res ...
