Toyota Tundra Service Manual: Removal

REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

  • Wear protective gloves when removing the exhaust pipe assembly.
  • The exhaust pipe assembly is extremely hot immediately after the engine has stopped.
  • Confirm that the exhaust pipe assembly has cooled down before removing it.

PROCEDURE

1. REMOVE FRONT EXHAUST PIPE ASSEMBLY

(See page )

2. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)

(a) Using SST, remove the air fuel ratio sensor.

SST: 09224-00010

3. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY

4. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)

(a) Disconnect the air fuel ratio sensor connector.

(b) Using SST, remove the air fuel ratio sensor.

SST: 09224-00010

    On-vehicle Inspection

    Camshaft Oil Control Valve

    See More:

    Toyota Tundra Service Manual > Sliding Roof System: Switch Failure (B2342)
    DESCRIPTION This DTC is output when the sliding roof drive gear (sliding roof ECU) detects that the SLIDE or TILT switch in the roof console box (sliding roof switch) is stuck for 30 seconds or more. DTC Code DTC Detection Condition Trouble Area B2342 Sliding roof drive gear (sliding roof ECU) detec ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2025 Copyright www.ttundra.com
    0.0094