On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. REMOVE FUEL PUMP RELAY (F/PMP) (a) Remove the fuel pump relay from the engine room relay block. 2. INSPECT FUEL PUMP RELAY 
(a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the fuel pump relay. 3. INSTALL FUEL PUMP RELAY (a) Install the fuel pump relay to the engine room relay block. |
Toyota Tundra Service Manual > Oil Pump: Reassembly
REASSEMBLY PROCEDURE 1. INSTALL OIL PUMP RELIEF VALVE (a) Coat the oil pump relief valve with engine oil. (b) Install the relief valve and relief valve spring into the oil pump cover hole. (c) Install the plug. Torque: 53 N·m {540 kgf·cm, 39 ft·lbf} 2. INSTALL OIL PUMP COVER (a) Install the drive ...
