Toyota Tundra Service Manual: Removal

REMOVAL

PROCEDURE

1. REMOVE NO. 1 ENGINE UNDER COVER

2. REMOVE V-BANK COVER SUB-ASSEMBLY

3. DRAIN ENGINE COOLANT

4. REMOVE ENGINE COOLANT TEMPERATURE SENSOR

(a) Disconnect the sensor connector.

(b) Using a 19 mm ball joint lock nut wrench, remove the sensor.

(c) Remove the gasket from the sensor.

    Installation

    Fuel Pump Relay

    See More:

    Toyota Tundra Service Manual > Rear Leaf Spring: Removal
    REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedures for the RH side and LH side. The procedures listed below are for the LH side. PROCEDURE 1. SUPPORT BODY WITH SAFETY STANDS (a) Jack up and support the body on safety stands. (b) Lower the axle housing until the leaf spring tension is free ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0185