Toyota Tundra Service Manual: Panel Switches do not Function

Toyota Tundra Service Manual / Audio, Visual, Telematics / Audio / Video / Audio And Visual System / Panel Switches do not Function

CAUTION / NOTICE / HINT

NOTICE:

After replacing the radio and display receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary (w/ SDARS System).

PROCEDURE

1.

CHECK PANEL SWITCH

(a) Check for foreign matter on the display.

OK:

The display is clean.

NG

REMOVE ANY FOREIGN MATTER FOUND
OK

2.

CHECK PANEL SWITCH (OPERATION CHECK)

(a) Enter the "Panel & Steering Switch Check Mode" screen. [Refer to Check Panel & Steering Switch in Operation Check (See page )]

(b) Operate the abnormal switch and check if the switch status is correctly displayed.

OK:

The switch status is correctly displayed as operated.

Result

Result

Proceed to

OK (for Column Shift Type)

A

OK (for Floor Shift Type)

B

NG

C
A

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

B

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

C

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

    Operation Check

    Parking Brake Switch Circuit

    See More:

    Toyota Tundra Service Manual > Front Drive Shaft Assembly(for 4wd): Disassembly
    DISASSEMBLY PROCEDURE 1. REMOVE INBOARD JOINT BOOT CLAMP (a) Using a side cutter, cut the 2 inboard joint boot clamps and remove them. 2. DISCONNECT INBOARD JOINT BOOT (a) Disconnect the inboard joint boot from the inboard joint shaft. 3. REMOVE INBOARD JOINT SHAFT (a) Place matchmarks on the inboar ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2021 Copyright www.ttundra.com
    0.063