Components COMPONENTS ILLUSTRATION  Installation INSTALLATION PROCEDURE 1. INSTALL CRANKSHAFT POSITION SENSOR  (a) Install the sensor with the bolt. Torque: 10 N·m {102 kgf·cm, 7 ft·lbf} (b) Connect the sensor connector. 2. INSTALL CRANKSHAFT POSITION SENSOR PROTECTOR
Removal REMOVAL PROCEDURE 1. REMOVE CRANKSHAFT POSITION SENSOR PROTECTOR
2. REMOVE CRANKSHAFT POSITION SENSOR  (a) Disconnect the sensor connector. (b) Remove the bolt and sensor. |
Toyota Tundra Owners Manual > Steps to take in an
emergency: If the engine will not
start
If the engine will not start even though correct starting procedures are being followed, consider each of the following points. The engine will not start even though the starter motor operates normally. One of the following may be the cause of the problem: There may not be sufficient fuel in the ve ...
