Toyota Tundra Service Manual: Installation

Toyota Tundra Service Manual / Engine, Hybrid System / 1ur-fe Engine Control / Engine Coolant Temperature Sensor / Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

Perform "Inspection After Repairs" after replacing the engine coolant temperature sensor (See page ).

PROCEDURE

1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR

HINT:

Perform "Inspection After Repairs" after replacing the engine coolant temperature sensor (See page ).

(a) Install a new gasket to the sensor.

(b) Using a 19 mm ball joint lock nut wrench, install the sensor.

Torque:

20 N·m {200 kgf·cm, 14 ft·lbf}

NOTICE:

Use the formula to calculate special torque values for situations where ball joint lock nut wrench is combined with a torque wrench (See page ).

2. ADD ENGINE COOLANT

3. INSPECT FOR COOLANT LEAK

4. INSTALL V-BANK COVER SUB-ASSEMBLY

5. INSTALL NO. 1 ENGINE UNDER COVER

See More:

Toyota Tundra Service Manual > Wireless Door Lock Control System: Registration
REGISTRATION CAUTION / NOTICE / HINT HINT: Register a new recognition code when replacing the door control transmitter assembly or the door control receiver. Add mode is used to retain the codes that have already been registered while registering a new recognition code. This mode is used when adding ...

Toyota Tundra Service Manual: Installation

Inspection

Removal

See More:

Toyota Tundra Owners Manual

Toyota Tundra Service Manual