ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY (a) Apply the parking brake and turn the ignition switch to ON. (b) Depress the brake pedal and check that the engine starts when the shift lever is in N or P, but does not start when the shift lever is in other positions. (c) Check that the back-up light illuminates and the reverse warning buzzer sounds when the shift lever is in R, but do not function when the shift lever is in other positions. |
Toyota Tundra Service Manual > Brake Actuator: Installation
INSTALLATION CAUTION / NOTICE / HINT NOTICE: In case of replacing the skid control ECU, perform the zero point calibration of the steering angle sensor, master cylinder pressure sensor, and yaw rate and deceleration sensor (See page ). PROCEDURE 1. INSTALL BRAKE ACTUATOR ASSEMBLY (a) Tighten the 3 n ...
