Toyota Tundra Service Manual: Front Camera Module Circuit (C1AA0)

DESCRIPTION

When an internal malfunction is detected in the forward recognition camera, DTC C1AA0 is stored.

DTC No.	Detection Item	DTC Detection Condition	Trouble Area
C1AA0	Front Camera Module Circuit	3 seconds after the ignition switch is turned to ON, the forward recognition camera detects an internal malfunction.	Forward recognition camera

CAUTION / NOTICE / HINT

NOTICE:

When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle. As a result, a DTC may be stored.
If the forward recognition camera has been replaced with a new one, be sure to perform Forward Recognition Camera Axis Adjustment.
Click here

PROCEDURE

1.	CHECK FOR DTCs (FORWARD RECOGNITION CAMERA SYSTEM)

(a) Clear the DTCs.

Click here

(b) Make sure that the DTC detection conditions are met.

HINT:

If the conditions are not met, the system cannot detect the malfunction.

Click here

Result	Proceed to
DTC C1AA0 is not output	A
DTC C1AA0 is output	B

USE SIMULATION METHOD TO CHECK

2.	REPLACE FORWARD RECOGNITION CAMERA

(a) Replace the forward recognition camera.

Click here

(b) Perform forward recognition camera axis adjustment.

Click here

END

Toyota Tundra Service Manual > Multiplex Tilt And Telescopic Ecu(for Power Tilt And Power Telescopic Steering Column): Installation
INSTALLATION PROCEDURE 1. INSTALL MULTIPLEX TILT AND TELESCOPIC ECU (a) Attach the claw to install the multiplex tilt and telescopic ECU. (b) Connect the ECU connector. 2. INSTALL NO. 3 AIR DUCT SUB-ASSEMBLY Click here 3. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY Click here 4. INSTALL LOW ...

Toyota Tundra Owners Manual