DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Chassis / Front Recognition Camera / Trouble Codes. (e) Check for details of the DTCs. Click here
CLEAR DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Chassis / Front Recognition Camera / Clear DTCs. (e) Clear the DTCs. |
Toyota Tundra Service Manual > Brake Actuator: Installation
INSTALLATION CAUTION / NOTICE / HINT NOTICE: In case of replacing the skid control ECU, perform the zero point calibration of the steering angle sensor, master cylinder pressure sensor, and yaw rate and deceleration sensor (See page ). PROCEDURE 1. INSTALL BRAKE ACTUATOR ASSEMBLY (a) Tighten the 3 n ...
