DTC CHECK / CLEAR 1. CHECK DTC (a) Check the DTCs. (1) Connect the Techstream to the DLC3. (2) Turn the ignition switch to ON. (3) Turn the Techstream on. (4) Read the DTCs following the prompts on the Techstream screen. Enter the following menus: Chassis / Four Wheel Drive / Trouble Codes. (5) Check the details of the DTCs (See page
2. CLEAR DTC (a) Clear the DTCs. (1) Connect the Techstream to the DLC3. (2) Turn the ignition switch to ON. (3) Turn the Techstream on. (4) Operate the Techstream to clear the DTCs. Enter the following menus: Chassis / Four Wheel Drive / Trouble Codes. (5) According to the display on the Techstream, select the trouble code data display with the clear button. |
Toyota Tundra Service Manual > Starter(for 1.6 Kw Type): Inspection
INSPECTION PROCEDURE 1. INSPECT STARTER ASSEMBLY CAUTION: As a large electric current passes through the cable during this inspection, a think cable must be used. If not, the cable may became hot and cause injury. NOTICE: Perform each of the following tests within 3 to 5 seconds. (a) Perform a pull- ...
).
