General Maintenance GENERAL MAINTENANCE PROCEDURE 1. INSPECT BRAKE PEDAL AND PARKING BRAKE (a) Inspect the brake pedal and parking brake.
2. INSPECT BRAKE LINE PIPES AND HOSES HINT: Work in a well-lighted area. Turn the front wheels fully to the right or left before beginning the inspection.
(b) Check all the clamps for tightness and the connections for leakage. (c) Check that the hoses and lines are not near sharp edges, moving parts or the exhaust system. (d) Check that the lines are installed properly and pass through the center of the grommets. 3. INSPECT BRAKE LININGS AND DRUMS, PADS AND DISCS (a) Check the brake linings and drums of the parking brake (See page
(b) Check the brake pads and discs.
HINT: ![]()
4. INSPECT BRAKE FLUID (Except North America) (a) Inspect the brake fluid (See page
5. REPLACE BRAKE FLUID (Except North America) (a) Replace the brake fluid (See page |
Toyota Tundra Service Manual > Dynamic Radar Cruise Control System: Distance Control Switch Circuit
DESCRIPTION The distance control switch is used to set the distance for vehicle-to-vehicle distance control mode. The distance control switch is installed in the steering pad switch assembly. The vehicle-to-vehicle distance set value can be changed by operating the steering pad switch assembly (dist ...