INSPECTION PROCEDURE 1. INSPECT REAR DOOR LOCK ASSEMBLY LH (a) Check the door lock motor. (1) Apply battery voltage to the door lock and check operation of the door lock. 
OK:
(b) Check the door lock position switch. (1) Measure the resistance according to the value(s) in the table below. Standard resistance:
2. INSPECT REAR DOOR LOCK ASSEMBLY RH (a) Check the door lock motor. (1) Apply battery voltage to the door lock and check operation of the door lock. 
OK:
(b) Check the door lock position switch. (1) Measure the resistance according to the value(s) in the table below. Standard resistance:
|
Toyota Tundra Service Manual > Vehicle Stability Control System: Calibration
CALIBRATION DESCRIPTION (a) Refer to the table below and then perform the necessary operation according to the part to be replaced in order to perform calibration. Replacement Part or Procedure Necessary Procedures Skid control ECU (brake actuator assembly) Perform system variant learning and accele ...
