Toyota Tundra Service Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT DECK LIGHT SWITCH ASSEMBLY

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Switch Condition

Specified Condition

5 (CCTY) - 9 (CGON)

Cargo light switch ON

Below 1 Ω

Cargo light switch DOOR

Cargo light switch OFF

10 kΩ or higher

10 (CGLP) - 7 (E)

Cargo light switch ON

Below 1 Ω

Cargo light switch DOOR

10 kΩ or higher

Cargo light switch OFF

If the result is not as specified, replace the deck light switch assembly.

Text in Illustration

*a

Component without harness connected

(Deck Light Switch Assembly)

(b) Check the illumination.

(1) Apply battery voltage to the connector and check the illumination condition.

OK:

Measurement Condition

Specified Condition

Battery positive (+) → Terminal 1 (ILL+)

Battery negative (-) → Terminal 4 (ILL-)

Illuminates

If the result is not as specified, replace the deck light switch assembly.

Text in Illustration

*a

Component without harness connected

(Deck Light Switch Assembly)

    Components

    Installation

    See More:

    Toyota Tundra Service Manual > Vane Pump(for 3ur-fe, 3ur-fbe): Inspection
    INSPECTION PROCEDURE 1. INSPECT VANE PUMP SHAFT AND BUSH IN VANE PUMP FRONT HOUSING (a) Using a micrometer, measure the diameter (a) of the vane pump shaft with vane pump pulley. (b) Using a caliper gauge, measure the inside diameter (b) of the vane pump front housing. (c) Subtract (a) from (b) to c ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0305