Toyota Tundra Service Manual: Fog Light Relay

On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT FOG LIGHT RELAY

(a) Remove the fog light relay from the engine room relay box.

(b) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

3 - 5

Battery voltage not applied to terminals 1 and 2

10 kΩ or higher

Battery voltage applied to terminals 1 and 2

Below 1 Ω

If the result is not as specified, replace the fog light relay.

(c) Install the fog light relay to the engine room relay box.

    Removal

    Footwell Light

    See More:

    Toyota Tundra Service Manual > Wf1am Transfer: 4wd Control Ecu
    ComponentsCOMPONENTS ILLUSTRATION InstallationINSTALLATION PROCEDURE 1. INSTALL 4 WHEEL DRIVE CONTROL ECU (a) Connect the 2 connectors. (b) Install the 4 wheel drive control ECU with the 2 bolts, and then tighten them in the order shown in the illustration. Torque: 8.0 N·m {82 kgf·cm, 71 in·lbf} ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2026 Copyright www.ttundra.com
    0.0175