REMOVAL PROCEDURE 1. REMOVE FRONT DOOR SCUFF PLATE LH (a) for Double Cab: Click here (b) for CrewMax: Click here 2. REMOVE COWL SIDE TRIM BOARD LH Click here 3. REMOVE INSTRUMENT SIDE PANEL LH Click here 4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH Click here 5. REMOVE INTERIOR ROOM LIGHT SWITCH ASSEMBLY 
(a) Using a screwdriver, detach the 2 claws and remove the interior room light switch assembly. HINT: Protective tape the screwdriver tip before use. |
Toyota Tundra Service Manual > Vehicle Stability Control System: Brake Actuator Operation Sound is Loud during Initial Check
CAUTION / NOTICE / HINT NOTICE: When replacing the skid control ECU (brake actuator assembly), perform system variant learning and acceleration sensor zero point calibration. Click here PROCEDURE 1. PERFORM ROAD TEST (a) After turning the ignition switch to ON, compare the operating sound of the bra ...
