INSTALLATION PROCEDURE 1. INSTALL COMBINATION METER ASSEMBLY (a) Pass the combination meter assembly between the steering wheel assembly and instrument panel. (b) Connect the 2 connectors and attach the wire harness clamp. 
(c) Install the combination meter assembly with the 4 screws. 2. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (a) for Column Shift Type: Click here (b) for Floor Shift Type: Click here 3. INSTALL INSTRUMENT CLUSTER FINISH PANEL ORNAMENT (a) for Column Shift Type: Click here (b) for Floor Shift Type: Click here 4. INSTALL NO. 2 SWITCH HOLE BASE Click here 5. INSTALL UPPER STEERING COLUMN COVER (for Column Shift Type) Click here 6. INSTALL LOWER STEERING COLUMN COVER (for Column Shift Type) Click here 7. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH Click here 8. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH Click here 9. INSTALL COWL SIDE TRIM BOARD LH Click here 10. INSTALL FRONT DOOR SCUFF PLATE LH (a) for Double Cab: Click here (b) for CrewMax: Click here 11. INSTALL LOWER CENTER INSTRUMENT COVER (for Column Shift Type) Click here 12. INSTALL INSTRUMENT SIDE PANEL LH Click here 13. INSTALL NO. 1 INSTRUMENT PANEL REGISTER SUB-ASSEMBLY Click here 14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Click here 15. RESTORE AUTOAWAY/RETURN FUNCTION (for Power Tilt and Power Telescopic Steering Column) (a) Restore the Autoaway/Return function setting to the previous condition by changing the customize parameter. Click here |
Toyota Tundra Service Manual > Satellite Radio Tuner(for Floor Shift Type): Removal
REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page ). 2. ...
