INSPECTION PROCEDURE 1. INSPECT FRONT SEAT OUTER BELT ASSEMBLY ![]() CAUTION: Do not disassemble the retractor. (a) Before installing the seat belt, check the ELR. (1) When the inclination of the retractor is 15° or less from its installed position, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45° from its installed position, check that the belt locks. If the operation is not as specified, replace the seat belt assembly. (b) for Passenger's Seat only: Check the fastening function of the child restraint system. NOTICE: The check should be performed with the outer belt installed. (1) When the belt is pulled out fully, the belt should automatically start to retract. (2) After the belt has fully retracted, the belt should be able to be pulled out and retracted again. If the operation is not as specified, replace the belt assembly. |
Toyota Tundra Service Manual > Outer Rear View Mirror: Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL OUTER MIRROR COVER LH (for Extended Type) (a) Attach the 2 claws to install the outer mirror cover LH. 2. INSTALL SIDE TURN SIGNAL LIGHT LENS ...