Toyota Tundra Service Manual: Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

• Use the same procedures for the LH side and RH side.
• The procedures listed below are for the LH side.

PROCEDURE

1. INSTALL FRONT SEAT OUTER BELT ASSEMBLY

(a) Align the vehicle's claws with the seat belt retractor positioning holes.

(b) Install the seat belt with the 2 bolts.

HINT:

First install the bolt A, and then install bolt B.

Torque:

for bolt A :

12.5 N·m {127 kgf·cm, 9 ft·lbf}

for bolt B :

42 N·m {428 kgf·cm, 31 ft·lbf}

(c) Connect the pretensioner connector as shown in the illustration.

(d) Install the shoulder anchor to the shoulder belt anchor adjuster with the nut. Torque: 42 N·m {428 kgf·cm, 31 ft·lbf}

2. INSTALL CENTER PILLAR GARNISH

3. INSTALL LOWER CENTER PILLAR GARNISH

(a) Attach the 7 clips and 2 claws to install the pillar garnish.

(b) Install the seat belt anchor with the bolt. Torque: 42 N·m {428 kgf·cm, 31 ft·lbf}

(c) Attach the 2 claws to install the cover.

4. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP

5. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP

6. INSTALL FRONT DOOR SCUFF PLATE

7. INSTALL REAR DOOR SCUFF PLATE

8. INSTALL FRONT SEAT ASSEMBLY

(a) for Manual Seat:

Install the front seat (see page ).

(b) for Power Seat:

Install the front seat (see page ).

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

10. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light (see page ).