INSPECTION PROCEDURE 1. INSPECT FRONT NO. 2 SPEAKER ASSEMBLY (for Standard) (a) When there is a malfunction such as noise from a speaker or no sound at all, replace the speaker with a new one and check that the malfunction disappears. OK: Malfunction disappears. HINT:
2. INSPECT FRONT NO. 2 SPEAKER ASSEMBLY (for 12 Speakers)  (a) Measure the resistance according to the value(s) in the table below. Standard resistance:
If the result is not as specified, replace the front No. 2 speaker assembly. Text in Illustration
3. INSPECT FRONT NO. 4 SPEAKER ASSEMBLY (for Standard) (a) Temporarily replace the front No. 4 speaker assembly with a new or normally functioning one. OK: Malfunction disappears. HINT: Connect the connectors to the front No. 4 speaker assembly. 4. INSPECT FRONT NO. 4 SPEAKER ASSEMBLY (for 12 Speakers)  (a) Measure the resistance according to the value(s) in the table below. Standard resistance:
If the result is not as specified, replace the front No. 4 speaker assembly. Text in Illustration
|
Toyota Tundra Service Manual > Starter(for 1.6 Kw Type): Inspection
INSPECTION PROCEDURE 1. INSPECT STARTER ASSEMBLY CAUTION: As a large electric current passes through the cable during this inspection, a think cable must be used. If not, the cable may became hot and cause injury. NOTICE: Perform each of the following tests within 3 to 5 seconds. (a) Perform a pull- ...
