REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After
turning the ignition switch off, waiting time may be required before
disconnecting the cable from the battery terminal. Therefore, make sure
to read the disconnecting the cable from the battery terminal notice
before proceeding with work (See page 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page
3. REMOVE CENTER LOWER INSTRUMENT COVER 4. REMOVE AIR CONDITIONING CONTROL ASSEMBLY 5. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY
(c) Disconnect each connector and remove the radio and display receiver assembly with bracket. 6. REMOVE NO. 1 NAVIGATION WIRE (w/ Satellite Radio)
7. REMOVE NO. 1 RADIO RECEIVER BRACKET ![]()
(a) w/ Satellite Radio: Remove the 5 bolts and No. 1 radio receiver bracket. (b) w/o Satellite Radio: Remove the 3 bolts and No. 1 radio receiver bracket. 8. REMOVE NO. 2 RADIO RECEIVER BRACKET ![]()
(a) w/ Satellite Radio: Remove the 5 bolts and No. 2 radio receiver bracket. (b) w/o Satellite Radio: Remove the 3 bolts and No. 2 radio receiver bracket. 9. REMOVE STEREO COMPONENT TUNER ASSEMBLY (w/ Satellite Radio)
|
Toyota Tundra Service Manual > Vehicle Stability Control System: Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Vehicle Stability Control System DTC No. Detection Item Link C1201 Engine Control System Malfunction C1225 SM Solenoid Circuit C1226 SA2 Solenoid Circuit C1227 SA3 Solenoid Circuit C1228 STR Solenoid Circuit C1234 Yaw Rate Sensor C1237 Speed Sensor Rotor Faulty C1241 Lo ...