DTC CHECK / CLEAR 1. CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / (desired system) / Trouble Codes. (e) Check for DTCs by following the directions on the Techstream screen. HINT: Refer to the Techstream operator's manual for further details. 2. CLEAR DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / (desired system) / Trouble Codes. (e) Clear the DTCs by following the directions on the Techstream screen. HINT: Refer to the Techstream operator's manual for further details. |
Toyota Tundra Service Manual > Engine Unit: Inspection
INSPECTION PROCEDURE 1. INSPECT CYLINDER HEAD SET BOLT (a) Using a vernier caliper, measure the length of the cylinder head bolt from the seat to the end. Standard length: 141.3 to 142.7 mm (5.56 to 5.62 in.) Maximum length: 143.7 mm (5.66 in.) If the length is more than the maximum, replace the cyl ...
