Toyota Tundra Service Manual: Data List / Active Test

DATA LIST / ACTIVE TEST

1. DATA LIST

HINT:

Using the Techstream to read the Data List allows values or status of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the DATA LIST information early in troubleshooting is one way to save diagnostic time.

NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

(a) Warm up the engine.

(b) Turn the ignition switch OFF.

(c) Connect the Techstream to the DLC3.

(d) Turn the ignition switch ON.

(e) Turn the Techstream on.

(f) Enter the following menus: Body / Combination Meter / Data List.

(g) According to the display on the Techstream, read the "Data List".

Combination Meter

Tester Display

Measurement Item/Range

Normal Condition

Diagnostic Note

Washer Switch

Washer fluid level warning switch / ON or OFF

ON: Washer jar is empty

OFF: Washer jar is full

-

    Wiper And Washer System

    Parts Location

    See More:

    Toyota Tundra Service Manual > Lin Communication System: Front Passenger Side Door ECU Communication Stop (B2322)
    DESCRIPTION This DTC is stored when LIN communication between the front power window regulator motor assembly RH and main body ECU (multiplex network body ECU) stops for 10 seconds or more. DTC No. DTC Detection Condition Trouble Area B2322 No communication between the front power window regulator m ...

    Toyota Tundra Owners Manual

    Toyota Tundra Service Manual

    © 2025 Copyright www.ttundra.com
    0.0098